On Site Injector Extraction, Covering the Wiltshire Area and surrounding area

Diesel Engineer

01225 705858

Injector & Glow Plug Removal Specialist

Complete engine engineering service

Specialist in Cylinder Head Reconditioning

T.G.Norris Services

T.G.Norris is a small family run diesel engineering company. Based in Melksham, Wiltshire we have a 'state of the art' engineering workshop configured to fully meet the requirements of today's diesel repair and overhaul.

We offer a fully mobile service as well as our main engineering workshop. So we can come to you to perform detailed engineering tasks on your vehicle. From specialist heli-coil replacement to injector removal and refitting we can cover all aspects encountered with a wealth of experience and some of our own.

Full engineering workshop

Milling and Surfacing

After fitting new cylinder liners the whole engine block is resurfaced to ensure the level of the new liners is true to the surface area of the engine block. This will provide the correct engineered surface for the cylinder head gasket and cylinder head when assembled.

 

Milling and Surfacing

Part of the full overhaul of this cylinder head included the surfacing of the inlet and outlet ports. Previously there had been a poor fit and erosion of the matted surfaces had taken place. This was rectified by building up the surface with weld and then milling the port surface back to the correct tolerances.

 

Brake Drums and discs

Here is an example of a brake drum being resurfaced.

Flywheel Resurfacing

With our fully equipped engineering workshop, there is practically no engineering task we cannot handle. Here you can see a flywheel being resurfaced.